Wavetronix SmartSensor 105 (SS-105) - Quick-reference Guide ( Uživatelský manuál stáhnout pdf (Strana 3)

Verify the lane conﬁguration

1 Click Finished on the Lane Conguration page and the

View Trac (Event Data) page will appear.

2 Compare the trac on the road to the event information

shown in SmartSensor Manager.

View Event Counter – Allows you to verify real-time

volume counter lane by lane.

Event Log On/O – Allows you to log the current infor

mation.

View Event Log – Allows you to open the current event

log le in a text editor.

Actuation/Event Toggle – Allows you to change between Actuation and Event modes.

Viewing lane data

Clicking on the View Event Counter button will bring up a real-time volume counter.

Each time a vehicle enters or leaves the radar detection zone, the volume for the cor-

responding lane will increment accordingly.

˽ Click the Pause button to pause the lane data counter.

˽ Click the Play button to resume counting.

˽ Click the Reset button to clear the volume count and begin a new count.

Any vehicles that were detected by the SmartSensor while the event counter was

paused will not be shown in Volume.

Viewing interval data

e Interval Data screen allows you to verify interval data accu-

racy.

1 Specify the interval length in the Interval (Bin) Size eld by

clicking the Edit button.

2 Type the desired interval length in seconds.

3 Click Submit.

4 Synchronize the sensor time to your computer’s UTC time,

by clicking the synchronize button (the button with two

overlapping clocks). is will cause intervals to begin and end

at the expected time.

e other two buttons allow you to turn the interval data logging on/o and view the interval data log.

1 2 3 4

Žádné komentáře

Wavetronix SmartSensor 105 (SS-105) - Quick-reference Guide ( Uživatelský manuál Strana 3