Wavetronix SmartSensor HD (101-0415) - Quick-reference Guide Uživatelský manuál stáhnout pdf (Strana 2)

Attach the mount bracket to the pole:

1 Insert the stainless steel straps through the slots in the mount

bracket.

2 Position the mount on the pole so that the head of the mount is

pointing towards the middle of the lanes of interest.

3 Tighten the strap screws partway. e sensor alignment will need

to be ne-tuned later, so keep the straps loose enough to be adjust-

able but tight enough to be secure.

Attach the sensor to the mount bracket:

1 Align the bolts on the sensor’s backplate with the holes in the mount bracket. e connector at the bot-

tom of the unit should be pointing towards the ground.

2 Place the lock washers onto the bolts aer the bolts are in the mount bracket holes.

3 read on the nuts and tighten.

Align the sensor to the roadway

Attach the SmartSensor cable

1 Tilt the sensor down so that the front is aimed at the center of the detection area.

Attach the sensor and mount bracket to the pole

1 Tear the tab o the silicon dielectric compound and squeeze

about 25% of it into the connector at the base of the sensor.

Wipe o any excess compound.

2 Insert the cable into the connector and twist clockwise until

you hear it click into place.

3 To avoid undue movement from wind, strap the cable to the

pole or run it through a conduit, but leave a small amount of

slack at the top of the cable to reduce strain.

2 Adjust the side-to-side angle as close to perpendicular to the ow of trac as possible. e side-to-side

alignment will be ne-tuned in step 10 using the SmartSensor Manager HD soware.

1 2 3 4

Žádné komentáře

Wavetronix SmartSensor HD (101-0415) - Quick-reference Guide Uživatelský manuál Strana 2