Wavetronix Click 112 (detector rack card) (CLK-112) - Quick-r Uživatelský manuál stáhnout pdf

Click 112/114 Contact Closure

INSTALLER QUICK-REFERENCE GUIDE

www.wavetronix.com

801.734.7200

Understand the device’s conﬁguration features

e following physical features allow you to congure the Click 112/114:

˽ Mode Switch – Allows you to cycle through and select menu and congura-

tion options.

˽ Level 1 LEDs – Light up to indicate menu options while cycling through the

menu. ey also have the following functions:

˿ Red – Lights up when the device has power

˿ Blue – Currently has no function

˿ Green – Lights up when the device is transmitting data

˿ Yellow – Lights up when the device is receiving data

˽ Level 2 LEDs – Light up to indicate conguration options. When the de-

vice is not in menu mode, these LEDs are o.

˽ Channel LEDs – e topmost bank of LEDs. ese light up to indicate

vehicle detection.

˽ DIP Switches – Located on the lower part of the circuit board (le face of the board, if you’re looking at

the faceplate). ese switches allow you to congure the device. is will be covered in greater detail in

Part 4.

www.wavetronix.com

801.734.7200

Mount and connect the device

Use the following steps to install the Click 112/114 rack cards:

1 If you’re using hardware conguration, set all DIP switches before

installing Click 112/114 devices (this will be covered in Part 4 of

this document).

2 Insert the cards into the rack.

3 Daisy-chain together all the cards in your installation, using short

RJ-11 jumper cables.

4 Connect the rst Click 112/114 card to the SmartSensor via a Click

200 or Click 222 surge protector and a 60” RJ-11 patch cord.

Note. Bus 1 should be used to connect to the sensor, and bus 2 for conguration.

Channel

1 2 3 4

PWR PU TD RD

Level 1

Mode Switch

Level 2

1 2 3 4

Shrnutí obsahu

Strany 1 - Click 112/114 Contact Closure

Click 112/114 Contact ClosureINSTALLER QUICK-REFERENCE GUIDEwww.wavetronix.com 801.734.72002 Understand the device’s conﬁguration featurese followin

Strany 2 - Select conﬁguration method

3 Select conﬁguration method4 Conﬁguration option 1: DIP switchese DIP switches on the circuit board can be used to change input mapping and the baud

Strany 3 - Reset to Default

5 Conﬁguration option 2: front panel menue front panel menu allows you to congure input mapping and baud rates. It can also reset the device to fact

Strany 4 - Select a driver

Komentáře k této Příručce

Žádné komentáře

Wavetronix Click 112 (detector rack card) (CLK-112) - Quick-r Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Zařízení Wavetronix Click 112 (detector rack card) (CLK-112) - Quick-r. Wavetronix Click 112 (detector rack card) (CLK-112) - Quick-reference Guide User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Wavetronix Click 112 (detector rack card) (CLK-112) - Quick-r