Wavetronix SMARTSENSOR 105 Instalační příručka stáhnout pdf (Strana 35)

SmartSensor 105 User Guide – Wavetronix LLC 9/20/07 - -

Appendix G – Cable Lengths

The following recommendations allow the user to provide reliable power to the

SmartSensor. The SmartSensor cable’s red and black wires provide a 20 AWG wire pair.

The other pairs on the SmartSensor cable are 22 AWG and are normally used for

communication.

Gauge Pairs

24 V 12 V

20 AWG 1-Pair 600 ft 110 ft

Additional 22 AWG Each Pai

Add 400 ft Add 75 ft

22 AWG 1st Pair 400 ft 75 ft

Additional 22 AWG Each Pai

Add 400 ft Add 75 ft

14 AWG 1-Pair 2500 ft 450 ft

12 AWG 1-Pair 3900 ft 700 ft

10 AWG 1-Pair 6000 ft 1050 ft

8 AWG 1-Pair 9900 ft 1750 ft

6 AWG 1-Pai

14,000 ft 2500 ft

Alternate Power Cables

PowerCable

SmartSensor Cable

Old SmartSensor Cable

Table 8 - Maximum Cable Length for Power (ft)

If the cable length is longer than 600 feet when operating at 24 V, it is possible to

increase the maximum cable length by wiring a pair of lines normally used for RS-232

communications with the red and black wires.

If the cable length is 200 feet or greater you cannot reliably use RS-232 communications.

To add 400 feet and achieve a maximum cable length of 1000 feet, connect the orange

wire (normally RTS) to the red wire and the brown wire (normally CTS) to the black

wire.

If your cable run is longer than 1000 feet, it is possible to sacrifice additional

communication pairs to increase the maximum cable length for power. However, you

may desire to communicate to the sensor over two independent channels, in which case

you will need to consider an alternate cable for power. The AWG for wire pairs that

achieve a 2000 ft maximum cable length or greater at 12 and 24 V are listed in Table 8.

To achieve reliable wired communications, the selected baud rate must be compatible

with the length of the cable run. The table below shows the cable length

recommendations for wired communications (see Table 9):

115.2 57.6 38.4 19.2 9.6

RS-485

300 ft 600 ft 800 ft 1000 ft 2000 ft

RS-232

40 ft 60 ft 100 ft 140 ft 200 ft

Baud Rate (Kbps)

Table 9 - Maximum Cable Length for Wired Communications (ft)

To provide two independent communication channels with a homerun cable length over

200 ft, convert the RS-232 data into RS-485 using a Click! 304 in a pole-mount cabinet

1 2 ... 30 31 32 33 34 35 36

Komentáře k této Příručce

Žádné komentáře

Wavetronix SMARTSENSOR 105 Instalační příručka Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Wavetronix SMARTSENSOR 105