Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Uživatelský manuál stáhnout pdf (Strana 123)

122 CHAPTER 11  TOOLS

Note

You cannot restore a backup ﬁle from a SmartSensor Advance device to a SmartSen-

sor Advance Extended Range device. The converse is also true.

If the restore process completes successfully, the conguration was loaded and saved to

FLASH.

e zone locations described in a conguration le are relative to the stop bar. e stop bar

frame of reference allows zones to be described in terms of their trac-related functions.

However, it is possible for some zone problems to arise if the channel conguration is re-

stored but the sensor position is not.

For a given sensor installation, some zones dened in a conguration le may not be en-

tirely within the sensor’s detection range. If this is the case, a message will appear stating the

number of congured zones that are invalid for the sensor’s position relative to the stop bar

and you will be prompted to accept the modied results of the restored conguration or to

cancel the restore altogether (see Figure 11.6).

Figure 11.6 – Out of Sensor’s Range

Note

If the modiﬁed template results are accepted, the invalid zones will be deleted from

the channel conﬁguration. It is strongly advised that you manually inspect the chan-

nel conﬁguration and make modiﬁcations as required. You should always verify chan-

nel performance before terminating the conﬁguration process.

If necessary, the desired conguration le can be copied and modied in a text editor to

accommodate the sensor’s position; or the channel can be congured using the soware.

Restoring to Factory Defaults

To restore the device to its factory defaults, use the Restore Factory Defaults button on the

Backup/Restore page.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 147 148

Žádné komentáře

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Uživatelský manuál Strana 123