Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Uživatelský manuál stáhnout pdf (Strana 86)

CHAPTER 7  CHANNELS-ALERTS-ZONES 85

Click here

to open the

range editor

Figure 7.19 – Zone Conﬁguration

Below is a description of each parameter in the zone section of the CAZ Setup screen (see

Figure 7.19).

Range (ft)

A zone is enabled when its range is dened. When a zone is enabled, the zone section of

the setup screen turns yellow; when a zone is disabled, the zone section turns light gray. A

detection must be within a zone’s range limits in order to activate that zone’s output. All

zone ranges in a given alert are congured in a single screen and may not overlap in range.

Click in the zone range display next to the range label to open the zone range editor (see

Figure 7.20).

Figure 7.20 – Zone Range Editor

To add (enable) a zone, drag the desired zone icon from the zone well to the roadway; to re-

move (disable) a zone, drag it from the roadway to the zone well (or anywhere o the road-

way). If a zone is moved to an invalid location, it will be returned to its previous location.

To change the range of a zone, drag the blue triangle markers up or down the roadway or

click the up/down arrows on either side of the screen (see Figure 7.21). e zone can be

placed anywhere on the roadway by clicking anywhere inside the zone and dragging it. e

minimum range is 50 . (15.2 m) from the sensor and the maximum range is 600 . (152.4

m) from the sensor.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 147 148

Žádné komentáře

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Uživatelský manuál Strana 86